BODAQ ITERIOR FILM

Inspect the type and condition of the substrate on which the film is to be installed before construction.

In the case of MDF, it is necessary to use MDF with a uniform density because the density affects adhesion and stability during construction.
Preparation
- - Check the condition of the type of surface which the film is to be applied before construction.
- - In the case of MDF, depending on the density, it affects the adhesion and stability in construction. Therefore, it is necessary to use.
MDF with uniform density.
Surface treatment operations should be aware of the following characteristics
- - Painted surface: It is necessary to remove the contaminants on the surface and proceed after the treatment of damaged surface.
- - Non-Painted surface: If the surface is rough, you should clean the surface with sandpaper first.
Prior to installation, check for any abnormality (product name, surface condition, flammability etc.) of the selected product.
When you build the site in weathers such as spring or autumn, or even during dawn, be sure to remove moisture that may remain on the wall.
Please keep the room temperature of the construction site at room temperature (15°C ~ 23°C) in order to remove moisture effectively
the adhesives of the product. If there is a gas generating substance or a wax ingredient on the base material (adhered surface), please note that the adhesive may weaken

The primer used in film construction shows the best performance and stability when using "Bodaq primer" produced by Hyundai L&C.

MDF, PB and other woods have a very high absorption rate of primer due to the nature of the material. In case of the cut side, it should be applied 2-3 times.
It should be dried for at least 2 hours, and the film should be attached with an appropriate amount of force (pressure)
※ Bodaq primer (water-based) should be stored in a cool, shaded place at room temperature. Please be careful when storing in winter because

This product has a special coating treatment on the surface to express the mixed texture of glossy and matt.
Be careful when rubbing the corners strongly, as the surface special coating layer may be damaged.
Deep emboss is applied to express the texture of real wood, so care should be taken as excessive tearing and frequent product detachment may tear the product.
When cleaning the surface after construction, be careful not to damage it using neutral detergent or water.

Due to the high hardness of the product, it is necessary to finish the product with sufficient force to prevent lifting of the corners and realize visual effects.

Because of the special coating treatment for non-scratches, Hera can be difficult to push during construction.
In order to express the matt effect properly, construction must be done in a clean environment.
If the construction is done with foreign substance between the adherend and the film adhesive surface, the surface cuts or protrusion marks are produced on the film surface as it is.
Overlapping may be difficult in this product line due to the special surface coating treatment.

Since the product is thick, overlapping may be difficult .
Since there is no surface film layer, special care must be taken to prevent damage to the surface while using Hera after construction.

Because the product is thick, it may be difficult to bend and overlap.
Since there is no film layer on the surface, special care must be taken not to damage the surface during the Hera operation after construction.

Since the product is thick, it must be applied with sufficient force while overlapping.

Since the color difference may occur between products (by printing LOT), it is necessary to check the LOT before construction.
The applying surface should be sanded and primer is recommended to reinforce adhesion.
In case of overlapping between products, certain patterns should be applied after primer application and, more force must be applied

Builder